ohgary wrote:
I suspect a machine shop could bend that back. I would look at replacing that roller as it looks like it might have been torqued as well. I would also inspect the deck below that area to see if there was any damage. Take a bit of force to bend that bow roller mount.
When you say replace the roller you mean the pin where the plastic roller rides? I looked under the deck and didn't see any damage in the anchor locker. The screw that is closest to the bow looks like itmay have come out/stripped the hole, but I won't know until I have a chance to remove it. If so, I will just drill and go to a larger hole.
If i need to replace it does anyone know what model or manufacturer makes this particular bow roller?