Cockpit Construction

sundog · **Joined:** 15 Aug 2008 18:14 **Posts:** 21

Can anyone tell me if the cockpit mold was a single peice or if had seams under the companionway. Mine has a seam that runs along the cockpit floor under the companionway entrance. There are two vertical seams that run from the edge of the companionway entrance down to the cockpit floor. I'm wondering if this is original construction of if the PO did some surgery.

I'm tracing a leak that ends up dripping on the engine and this is one possible source.

Thanks,
Mike
Sundog #207

Tortuga's Lie · **Joined:** 27 Oct 2006 10:32 **Posts:** 827

what is your hull #? I have #59 and it does not have any visible joint lines, so I guess ours is molded into one piece?

sundog · **Joined:** 15 Aug 2008 18:14 **Posts:** 21

Sundog is a 1979 K/CB hull #207. Built in Ohio.

Tartan37.com

Cockpit Construction

Who is online