 |
Skipper |
 |
Joined: 13 Feb 2011 21:19 Posts: 353 Location: Canyon Lake, TX
|
Clean, clean, CLEAN the stud on the throttle. Then spray some Corrosion-X or PB blaster on the nut. Let it stand for a day or so. Then try to remove the nut.
I was going to do this and pull the old o-ring out and replace it BUT....
I sheared the shaft and ended up having to pull the pump and send it in.
Your luck may vary.
_________________ Wayne Master and Commander of the Sailing Vessel Impetuous I'm not a complete idiot, some parts are missing. Subservient to no man except SWMBO Any day without dock lines is a GOOD day!
|
|